Siemens FC300 - Page 107

Signal input - channels 3 to 4
The Signal Input can be configured to either Dosing control, Totalizer reset, Remote zero adjust
or Force/Freeze output(s).

)&
2SHUDWLRQ0RGH
6LJQDO,QSXW
'HOD\7LPH
3RODULW\
3URFHHG
View
no.
Text Options/Description
4 Operation Mode Select the signal input functionality
5 Delay Time Set the signal input delay time
6 Polarity Set the signal input polarity
Gas Application wizard (menu item 1.5)
The Gas Application wizard will guide you through configuration of essential parameters for
measuring gas flow. As default Low Flow Cut-Off and Empty Tube Detection are disabled.
Actual volume flow is difficult to use with low pressure; hence we recommend to use Corrected
Volumeflow.



&RUU9ROXPHIORZ
)&
&RQILJXUH
(PSW\7XEH'HWHFWLRQ
(PSW\7XEH/LPLW
3URFHHG
'HIDXOW9DOXHV
View
no.
Text Options/Description
2 Default Values Select whether or not to use the default values
3-4 Configure Configure empty tube detection and limit
5 Corr. Volumeflow Configure settings for corrected volumeflow
Commissioning
6.3 Local commissioning
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA 107