Siemens FC300 - Page 274

HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
2.2.1.6.2 Upper warning limit Set upper warning limit. Warning
is triggered if mass flow value is
above the limit.
1) 1)
User
2.2.1.6.3 Lower warning limit Set lower warning limit. Warning
is triggered if mass flow value is
below the limit.
1) 1)
User
2.2.1.6.4 Lower alarm limit Set lower alarm limit. Alarm is
triggered if mass flow value is
below the limit.
1) 1)
User
2.2.1.6.5 Hysteresis Sets the hysteresis for alarm
and warning limits. The hystere‐
sis is the distance between the
limits for activation and deactiva‐
tion of an alarm/warning.
1) 1)
User
2.2.1.7 Flow adjustment
2.2.1.7.1 Adjustment factor Adjust displayed flow. Elimi‐
nates inaccuracies caused by
process conditions.
1 -1.999 to 1.999 Expert
2.2.2 Volume flow
2.2.2.1 Units Select unit for displayed volume
flow rate. Unit is not applied at
communication interface.
m
3/
h l/s, l/min, l/h, l/ d,
Ml/d, hl/s, hl/ min,
hl/h, hl/d, m
3
/s, m
3
/
min, m
3
/ h, m
3
/d,
Mm
3
/d, gal/s
(US), gal/min
(US), gal/h (US),
gal/d (US), Mgal/
d, gal/s (UK), gal/
min (Uk), gal/h
(UK), gal/d (UK),
bbl-beer/s, bbl-
beer/min, bbl-
beer/h, bbl-beer/
d, bbl/(US)s, bbl/
(US)min, bbl/
(US)h, bbl/(US)d,
kbbl/d, Mbbl/d,
bbl (US)/s, bbl
(US)/min, bbl
(US)/h, bbl (US)/
d, ft
3
/s, ft
3
/min, ft
3
/
h, ft
3
/d, Mft
3
/d, af/
min, af/h, af/d, in
3
/
s, in
3
/min, in
3
/h,
in
3/
d, yd
3
/s, yd
3
/
min, yd
3
/h, yd
3
/d,
bu/s, bu/min, bu/
h, bu/d, Custom
User
2.2.2.2 Custom units Define a name for the custom
units. The custom units can then
be selected in the units list.
1)
User
Default settings
B.2 Process Values
MASS 2100 & FC300 (FCT030)
274 Operating Instructions, 06/2017, A5E39789040-AA