Siemens FC300 - Page 33

● Measurement of process values:
– Mass flow
– Volume flow
– Standard volume flow (including normalized gas flows)
– Density
– Process media temperature
– Fraction A (mass flow or volume flow)
– Fraction B (mass flow or volume flow)
– Fraction A %
– Fraction B %
● Configurable upper and lower alarms and warning limits for all process values
● Independent low flow cut-off settings for mass flow and volume flow
● Automatic zero-point adjustment (initiated by host system)
● Process noise damping using digital signal processing (DSP).
● Three totalizers for summation of massflow, volumeflow and corrected volumeflow,
depending on setting, of:
– Mass flow measurement
– Volume flow measurement
– Fraction A and B measurement (mass flow or volume flow)
– Corrected volumeflow
● Empty pipe monitoring
● Simulation of process values:
– Mass flow
– Volume flow
– Standard volume flow
– Density
– Process media temperature
– Fraction A %
– Fraction B %
– Sensor frame temperature
● Simulation of all outputs
● Simulation and suppression of alarms
● Comprehensive diagnostics (NAMUR or Siemens standard) for troubleshooting and sensor
checking
● Firmware update
● Use in hazardous locations according to specification
Description
3.4 Features
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA 33