Siemens FC300 - Page 360

HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
2.4.5.8.9 Device alarms Select one or more Individual
alarms. The output is active
when one of the Individual
alarms occurs.
● 148 Transm.
Temp. above
alarm limit
● 149 Transm.
Temp. below
alarm limit
● 150 Sensor
signal
disrupted
● 159 Internal
error in
transmitter
User
2.4.5.8.10 Channel 1 alarms Select one or more Individual
alarms. The output is active
when one of the Individual
alarms occurs.
● 153 CH1 loop
cur. In lower
saturation
● 154 CH1 loop
cur. In upper
saturation
● 155 CH1 loop
current
deviation
● 158 CH 1
cable break
User
2.4.5.8.11 Input/output alarms (1) Select one or more Individual
alarms. The output is active
when one of the Individual
alarms occurs.
● 192 Dosing
time overrun
● 194 Invalid
proc. val.
During dosing
● 198 CH2
output
frequency too
low
● 199 CH2
output
frequency too
high
● 213 Invalid
dosing
configuration
● 214 Channel 2
simulated
● 217 Process
values frozen
● 218 All
outputs forced
Default settings
B.5 Inputs and outputs
MASS 2100 & FC300 (FCT030)
360 Operating Instructions, 06/2017, A5E39789040-AA