Siemens FC300 - Page 489

Table D-6 Signal output on CH2
Level 3 Level 4 Level 5
No. Name No. Name No. Name
2.4.2 CH2 - output 2.4.2.1 Operation mode
2.4.2.3 Active operation
2.4.2.4 Fail-safe activation condi‐
tion
2.4.2.5 Current output 2.4.2.5.1 Process value
2.4.2.5.2 Flow direction
2.4.2.5.3 Loop current scale
2.4.2.5.4 Upper range value
2.4.2.5.5 Lower range value
2.4.2.5.6 Damping value
2.4.2.5.7 Fail-safe behavior
2.4.2.5.8 Fail-safe value
2.4.2.5.9 Fail-safe minimum duration
2.4.2.6 Frequency output 2.4.2.6.1 Process value
2.4.2.6.2 Flow direction
2.4.2.6.3 Upper frequency value
2.4.2.6.4 Lower frequency value
2.4.2.6.5 Upper range value
2.4.2.6.6 Lower range value
2.4.2.6.7 Damping value
2.4.2.6.8 Fail-safe behavior
2.4.2.6.9 Fail-safe value
2.4.2.6.10 Fail-safe minimum duration
2.4.2.7 Pulse output 2.4.2.7.1 Process value
2.4.2.7.2 Flow direction
2.4.2.7.3 Pulse units
2.4.2.7.4 Amount
2.4.2.7.5 Pulses per amount
2.4.2.7.6 Pulse width units
2.4.2.6.7 Pulse width
2.4.2.7.8 Polarity
2.4.2.7.9 Fail-safe behavior
2.4.2.7.10 Fail-safe value
2.4.2.7.11 Fail-safe minimum duration
2.4.2.8 Digital output 2.4.2.8.1 Mode
2.4.2.8.2 Sensor alarms (group 1)
2.4.2.8.3 Sensor alarms (group 2)
2.4.2.8.4 Process alarms (1)
2.4.2.8.5 Process alarms (2)
2.4.2.8.8 Totalizers alarms
2.4.2.8.9 Device alarms
HMI menu structure
D.5 Menu item 2.4: Inputs and outputs
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA 489