257/617
Building Technologies Division User Manual LMS14… CC1U7471en
6 The settings in detail 28.01.2015
Line no. Operating line
2630 Auto deaeration procedure
Off
On
The procedure must be enabled via this parameter (On), allowing it to be started.
Deaeration takes place automatically, e.g. after an error in connection with
deaeration.
The function can also be triggered manually (for more detailed information, refer to
chapter Central functions).
Off
Function is deactivated.
On
Function is activated.
Line no. Operating line
2655 ON time deaeration
T_ON: On time of the boiler/heating circuit pumps in phases 2 and 4 of the
deaeration procedure.
Line no. Operating line
2656 OFF time deaeration
T_OFF: Off time of the boiler/heating circuit pumps in phases 2 and 4 of the
deaeration procedure.
Line no. Operating line
2657 Number of repetitions
Number of repetitions of pump switching cycles (T_ON, T_OFF) in phases 2 and 4
of the deaeration procedure.
Line no. Operating line
2662 Deaeration time heat circuit
Duration of deaeration with continuous control of the boiler/heating circuit pumps in
phase 1 of the deaeration procedure.
Line no. Operating line
2663 Deaeration time DHW
Duration of deaeration with continuous control of the boiler/DHW pumps in phase 3
of the deaeration procedure.
Line no. Operating line
7146 Deaeration function
7147 Type of venting
Line no. Operating line
7147 Type of venting
When the Deaeration function (7146) is activated, the Type of venting shows the
current phase of deaeration. When ended, deaeration shows None.
To Next Page
Loading...
Need help?
General
