561/617
Building Technologies Division User Manual LMS14… CC1U7471en
6 The settings in detail 28.01.2015
Line no. Operating line
Menu: Boiler
2441 Fan speed heating max
2442 Fan speed full charging max
2443 Fan sp start value inst WH
2444 Fan speed DHW max
2452 Controller delay speed
Menu: Burner control
9504 Required speed prepurging
9512 Required speed ignition
9524 Required speed LF
9529 Required speed HF
9626 Fan output/speed slope
9627 Fan output/speed Y-section
Presetting speed values via the operator terminal
Presetting of speed values for the different phases of sequence control:
For that, as described in chapter Burner control, flag Release QAA fan param [4337.1]
must be set to On.
7471d42e/0111
Figure 111: Fan parameters settable as load values via QAA75…/AVS37… - presetting the speed value
via the operator terminal
To Next Page
Loading...
Need help?
General
