Step by Step
Calling several persons simultaneously
36
3636
36
Using the switchover button
(HiPath 4000)
The switchover button that must be configured by your
system administrator can be used for the following
functions:
• consultation (return to the call being held or the con-
ference being held)
• toggling
• accepting a waiting call
• accepting a group call
Waiting call
You hear a call-waiting tone. Information about the call
appears in the display.
Press the flashing key to accept the waiting call. The
lamp is on.
Toggling
You are connected to two users. One user is waiting.
The switchover lamp is on
Press the key to switch over to the other user. The first
user waits.
Consultation
You call a second user. The second user does not an-
swer
Press the key to return to the waiting user or the waiting
conference.
Group call
You are connected to a single user. A group call is sig-
nalled. Information about the group call appears in the
display.
Press the flashing key to accept the group call. The first
user is placed on hold. The lamp is on.
Switchover
Switchover
Switchover
Switchover
To Next Page
Loading...
Need help?
General