Operator control and monitoring
9.2 Working with the user interface
SIMATIC MV420 / SIMATIC MV440
Operating Instructions, 04/2013, A5E02371045-06
177
9.2.5 Programs
The Programs task allows you to set the type of processing which the reader executes in a
cycle.
This task is the main task of the user interface and offers a wide range of options. They
enable you to adjust the reader to suit a wide range of read tasks in line with your
requirements.
Scope of programs
The "Programs" tasks includes:
● The image acquisition control functions
● The lighting selection
● Read task parameter assignment broken down into a sequence of read steps (steps)
● The output formatting of results
● Management and processing of verification and character font libraries
● The template for new programs
● The maximum number of programs: 15
Key function of the template
● The template contains the default settings. These are, for example, used to create new
programs in just a few clicks of the mouse with Adjustment - Save program.
● The settings made in the Adjustment - Image task are saved in the template.
● The template is used to create new programs in the "Programs" task.
To Next Page
Loading...
