Siemens SIMATIC MV440 - Preconditions for the Commands

Process interfacing via an automation system (PLC, PC)
10.3 Control with FB 45 and Ident profile
SIMATIC MV420 / SIMATIC MV440
Operating Instructions, 04/2013, A5E02371045-06
265
10.3.3.6 Preconditions for the commands
Command Trigger
source
Result
(binary)
Result string Control DISA No group error Processi
ng mode
Stop mode
Program
change (write
program
number)
∼ ∼ ∼ ASM ∼ YES YES YES
Read program
number
∼ ∼ ∼ ASM ∼ YES ∼ ∼
Write match
string
∼ ∼ ∼ ASM ∼ YES YES NO
Read match
string
∼ ∼ ∼ ASM ∼ YES YES NO
Set DISA bit ∼ ∼ ∼ ASM ∼ YES ∼ ∼
Reset DISA bit ∼ ∼ ∼ ASM ∼ YES ∼ ∼
XMATCH
1)
~ ~ ~ ASM ~ YES YES NO
Set digital out
1)
~ ~ ~ ASM ~ ~ ~ ~
Read result ∼ ∼ ASM ∼ ∼ YES YES NO
Trigger + read
result string
ASM ∼ ASM ∼ ∼ YES YES NO
Acknowledge
group error
∼ ∼ ∼ ASM ∼ NO NO NO
1) Not available on SIMATIC MV420 SR-B
∼ Selection is unimportant.
YES State must be satisfied.
NO State is not permitted.
ASM If the "PROFINET IP (Ident profile)" mode is set, you must select PROFINET IO;
otherwise, select ASM.
If you want to send a command, make sure that the selection criteria are met according to
the table above.
The columns "Trigger source", "Result", "Result string" and "Control" correspond to the
selection in the user interface (Connections ➜ Integration ➜ Connection).