Operator control and monitoring
9.2 Working with the user interface
SIMATIC MV420 / SIMATIC MV440
214 Operating Instructions, 04/2013, A5E02371045-06
● If you have switched off "Code sequence" mode (see Options - " Extras"), information on
the code currently used will be provided here.
● If you activated Code sequence mode, a drop-down list will be displayed. In the drop-
down list, you can decide whether the statistics of the entire code sequence or the
statistics of a specific code are displayed.
● If you simply want the statistics of the OK reads of a certain code, select the program
number of the relevant sequence from the drop-down list. With this setting, the "*" symbol
is displayed at several places.
● You can clear the statistics with the "Reset statistics" button if you have administration
authorization (see Options - "Security" tab).
Statistics are reset automatically if the program number is changed in processing mode.
Note
Detailed description of parameters in the online help
For a detailed description of the parameters and possible values, refer to the online help.
To Next Page
Loading...
