2 Getting Started “Configured Mode”
31
Commissioning PC Stations - Manual and Quick Start
Release 5/2005
C79000-G8976-C156-07
Steps in Project Engineering
Note:
You can create the S7 station shown in the screenshot only with STEP 7/HW Config.
In SIMATIC NCM PC, you can open and edit a project containing S7 stations. You can,
however, only create and download project engineering data for PC stations.
7. XDB export for offline mode:
When you save and compile the project, the project engineering data of the PC station is saved
in an XDB file.
You will find information on the storage location of the XDB file in the “Configuration” tab in the
Properties PC Station dialog.
To Next Page
Loading...
