Step What?
9 Opening the operator panel of the CPU (Page 83)
10 Compiling and downloading the AS data and OS data (Page 84)
11 Setting the CPU to RUN mode (Page 85)
Perform the configuration steps listed above in the order they are described.
7.5.2 How to select the network adapter in SIMATIC Shell
Introduction
The following describes how to select the network adapter adapter (communication module)
to be used to configure the PC stations.
Note
Perform the following steps on the engineering station and the SIMATIC PCS 7 BOX station.
Procedure
1. Double-click on the PC station (workstation) in the tree view of the Windows Explorer.
2. Select the "SIMATIC Shell" folder.
3. Select the Settings... command from the shortcut menu.
The "Select Terminal Bus" dialog box opens.
4. Select the network adapter you wish to use for the communication with the engineering
station.
Note
You can find additional information about the defaults of the Ethernet interface in the product
information for the BOX PC.
5. Click "OK" to apply your settings.
Note
When you confirm the next dialog box, the network connection to this PC station is
interrupted briefly.
6. Confirm the next dialog box.
The network adapter is reinitialized.
7. Select the menu command Start > Settings > Network Connections.
The "Network Connections" dialog box opens.
8. Select the menu command Advanced > Advanced Settings.
The "Advanced" dialog box opens.
9. Select the "Adapters and Bindings" tab.
Commissioning and configuration of SIMATIC PCS 7 BOX RTX
7.5 Configuring SIMATIC PCS 7 BOX RTX in the PCS 7 network
BOX (V8.1)
Function Manual, 03/2015, A5E32711362-AC 73
To Next Page
Loading...
Need help?
General
