9. Enter a descriptive name.
Recommendation: Select the name of the SIMATIC PC station under Start > Settings >
Control Panel > System > "Computer Name" tab > "Computer name".
10.Go to the "SIMATIC PC Station > CP Industrial Ethernet" folder in the hardware catalog.
Select the "IE General" object.
11.Drag the selected CP to the "Index 3" slot in the station window.
12.Click "OK".
13.Enter the network addresses of the SIMATIC PCS 7 BOX PC.
14.Click "OK".
15.Save and compile your changes.
16.Close HW Config.
Result
A project with the given settings and a PC station is created. The PC station is equipped with
the following components:
● CPU: Software PLC "WinLC RTX"
● WinCC application
Additional information
● Online help on the dialog boxes
7.5.4 How to rename the SIMATIC PC station
Introduction
The PCS 7 Wizard has created a new PCS 7 project for you.
The PCS 7 Wizard has automatically assigned a name to the SIMATIC PC station. Adapt this
name for the specific project.
Requirements
● The PCS 7 project has been created by the PCS 7 Wizard.
● The SIMATIC Manager is open.
● The component view is activated
Commissioning and configuration of SIMATIC PCS 7 BOX RTX
7.5 Configuring SIMATIC PCS 7 BOX RTX in the PCS 7 network
BOX (V8.1)
Function Manual, 03/2015, A5E32711362-AC 75
To Next Page
Loading...
Need help?
General
