Siemens SIMOTICS L-1FN3 Configuration Manual

Description of the motor
2.3 Technical features and environmental conditions
1FN3 linear motors
28 Configuration Manual, 10/2018, 6SN1197-0AB86-0BP2
Where applicable, the SIMOTICS motor series are in conformance with the following parts of
IEC / EN 60034:
Feature
Standard
Degree of protection
IEC / EN 60034-5
Cooling
1)
IEC / EN 60034-6
Type of construction
IEC / EN 60034-7
Connection designations IEC / EN 60034-8
Noise levels
1)
IEC / EN 60034-9
Temperature monitoring
IEC / EN 60034-11
Vibration severity grades
1)
IEC / EN 60034-14
1)
Standard component, e.g. cannot be applied to built-in motors
Relevant directives
The following directives are relevant for SIMOTICS motors.
European Low-Voltage Directive
SIMOTICS motors comply with the Low-Voltage Directive 2014/35/EU.
European Machinery Directive
SIMOTICS motors do not fall within the scope covered by the Machinery Directive.
However, the use of the products in a typical machine application has been fully assessed
for compliance with the main regulations in this directive concerning health and safety.
European EMC Directive
SIMOTICS motors do not fall within the scope covered by the EMC Directive. The products
are not considered as devices in the sense of the directive. Installed and operated with a
converter, the motor – together with the Power Drive System – must comply with the
requirements laid down in the applicable EMC Directive.
Eurasian conformity
SIMOTICS motors comply with the requirements of the Russia/Belarus/Kazakhstan (EAC)
customs union.
China Compulsory Certification
SIMOTICS motors do not fall within the scope covered by the China Compulsory
Certification (CCC).
CCC negative certification:
CCC product certification
(https://support.industry.siemens.com/cs/products?search=CCC&dtp=Certificate&mfn=ps&o
=DefaultRankingDesc&pnid=13347&lc)

Siemens SIMOTICS L-1FN3 Specifications

General

Brand	Siemens
Model	SIMOTICS L-1FN3
Category	Engine
Language	English