Preparation for use
7.2 Storage
1FN3 linear motors
480 Configuration Manual, 10/2018, 6SN1197-0AB86-0BP2
Table 7- 8 Biological ambient conditions
Table 7- 9 Chemical ambient conditions
Long-term storage: Class 1C1
Table 7- 10 Mechanically active ambient conditions
Long-term storage: Class 1S2
Table 7- 11 Mechanical ambient conditions
Long-term storage: Class 1M2
Storage in rooms and protection against humidity
The motors can be stored for up to two years under the following conditions:
● Apply a preservation agent (e.g. Tectyl) to bare external components if this has not
already been carried out in the factory.
● Store the motors as described in Section "Ambient conditions for long-term storage".
The storage room/area must satisfy the following conditions:
– Dry
– Dust-free
– Free of any vibration
– Well ventilated
– Protected against extreme weather conditions
– The air inside the room or space must be free of any aggressive gases
● Protect the motor against shocks and humidity.
● Make sure that the motor is covered properly.
To Next Page
Loading...
Need help?
General