Description of the motor
2.3 Technical features and environmental conditions
1FN3 linear motors
Configuration Manual, 10/2018, 6SN1197-0AB86-0BP2
27
Applications for continuous load motors
Combined with a drive system with closed-loop control, continuous load motors are well
suited as direct drives for linear motion, e.g. for:
● Oscillating motion (e.g. out-of-center machining)
● Applications with high process forces (e.g. grinding, turning, etc.)
● Vertical axes without weight compensation, quills
● Handling, Cartesian robots
You can use Motor Modules in the "blocksize", "booksize" or "chassis" formats.
Personal injury and material damage by noncompliance with directive 2006/42/EC
There is a risk of death, serious injury and/or material damage if Directive 2006/42/EC is
not carefully observed.
• The products included in the scope of delivery are exclusively designed for installation in
a machine. Commissioning is prohibited until it has been fully established that the end
product conforms with Directive 2006/42/EC.
• Please take into account all safety instructions and provide these to end users.
Please take note of national and international license terms when operating direct motors so
that no patent rights are violated.
Technical features and environmental conditions
2.3.1
Directives and standards
Standards that are complied with
The motors of the type series SIMOTICS S, SIMOTICS M, SIMOTICS L, SIMOTICS T,
SIMOTICS A, called "SIMOTICS motor series" below, fulfill the requirements of the following
directives and standards:
● EN 60034-1 – Rotating electrical machines – Dimensioning and operating behavior
● EN 60204-1 – Safety of machinery – Electrical equipment of machines; general
requirements
To Next Page
Loading...
