Description of the motor
2.2 Use for the intended purpose
1FN3 linear motors
26 Configuration Manual, 10/2018, 6SN1197-0AB86-0BP2
Use for the intended purpose
Risk of death and material damage as a result of incorrect use
There is a risk of death, serious injury and/or material damage when direct drives or their
components are used for a purpose for which they were not intended.
• Only use the motors for industrial or commercial plants and systems.
• Do not install the motors in hazardous zones if the motors have not been expressly and
explicitly designed and authorized for this purpose. Carefully observe any special
additional notes provided.
• Only use direct drives and their components for applications that Siemens has explicitly
specified.
• Protect the motors against dirt and contact with corrosive substances.
• Ensure that the installation conditions comply with the rating plate specifications and the
condition specifications contained in this documentation. Where relevant, take into
account deviations regarding approvals or country-specific regulations.
• Contact your local Siemens office if you have any questions relating to correct use.
• If you wish to use special versions and design versions whose technical details vary
from the motors described in this document, then you must contact your local Siemens
office.
Danger to life for wearers of active implants due to magnetic and electrical fields
Electric motors pose a danger to people with active medical implants, e.g. cardiac
stimulators, who come close to the motors.
• If you are affected, stay at a minimum distance of 500 mm from the motors (tripping
threshold for static magnetic fields of 0.5 mT according to the Directive 2013/35/EU).
Applications for peak load motors
Combined with a drive system with closed-loop control, peak load motors are well suited as
direct drives for linear motion, e.g. for:
● Highly dynamic and flexible machine tools
● Laser machining
● Handling
To Next Page
Loading...
Need help?
General