Mechanical properties
3.5 Service and inspection intervals
1FN3 linear motors
78 Configuration Manual, 10/2018, 6SN1197-0AB86-0BP2
Note
If incorrect changes or corrective maintenance are carried out by you or a third party on the
contractual objects, then for these and the consequential damages, no claims can be made
against Siemens regarding personal injury or material damage.
vice centers are available to answer any questions you may have. Siemens
Service Center addresses can be found at
http://www.siemens.com/automation/service&support
Sharp edges and falling objects
Sharp edges can cause cuts and falling objects can injure feet.
• Always wear safety shoes and safety gloves!
Maintenance
Performing maintenance work on the motor
Note
It is essential that you observe the safety inform
ation provided in this documentation.
As a result of their inherent principle of operation, linear motors are always wear-free.
To ensure that the motor functions properly and remains free of wear, the following
maintenance work needs to be carried out:
● Regularly check that the traversing paths are free
● Regularly clean the motor space and remove foreign bodies (e.g. chips)
● Regularly check the condition of the motor components.
● Check the current consumption in the defined test cycle (compare with values of the
reference travel)
To Next Page
Loading...
Need help?
General