Mechanical properties
3.5 Service and inspection intervals
1FN3 linear motors
Configuration Manual, 10/2018, 6SN1197-0AB86-0BP2
75
Risk of burning when touching hot surfaces
There is a risk of burning when touching hot surfaces immediately after the motor has been
operational.
• Wait until the motor has cooled down.
Risk of electric shock due to incorrect connection
There is a risk of electric shock if direct drives are incorrectly connected. This can result in
death, serious injury, or material damage.
• Motors must always be precisely connected up as described in these instructions.
• Direct connection of the motors to the three-phase supply is not permissible.
• Consult the documentation of the drive system being used.
To Next Page
Loading...
