Siemens SINAMICS G150 - Page 149

Electrical installation
4.10 Other connections
Converter cabinet units
Operating Instructions, 07/2016, A5E03347396A
149
Figure 4-32 Removing the CBE20 from the option slot on the Control Unit
X1400 Ethernet interface
Table 4- 47 Connector X1400, port 1 - 4
Pin
Signal name
Technical data
1
RX+
Receive data +
2
RX-
Receive data -
3
TX+
Transmit data +
4
Reserved, do not use
5
Reserved, do not use
6
TX-
Transmit data -
7
Reserved, do not use
8
Reserved, do not use
Screened
backshell
M_EXT Screen, permanently connected
Connector type: RJ45 socket