Siemens SINAMICS G150 - Page 204

Commissioning
5.3 Procedure for commissioning with STARTER
Converter cabinet units
204 Operating Instructions, 07/2016, A5E03347396A
Figure 5-7 Setting the interface - properties
Note
Activate PG/PC is the only master on the bus
You must activate PG/PC is the only master on bus
if no other master (PC, S7, etc.) is
available on the bus.
Note
Configure even without an interface
Projects can be created and PROFIBUS addresses for the
drive objects assigned even if a
PROFIBUS interface has not been installed on the PC.
To prevent bus addresses from being assigned more than once, only the bus addresses
available in the project are proposed.
When required, a manual address entry can also
be used to enter an already assigned
address.
⇒
After completion, click
OK
to confirm the settings and to return to the project wizard.