Operation
6.6 Control via the operator panel
Converter cabinet units
Operating Instructions, 07/2016, A5E03347396A
299
Table 6- 5 List of signals for the operation screen - VECTOR object
Scaling (100 %=...) See
table below
Factory setting (entry no.)
Speed setpoint upstream of ramp-function
generator
(1) r1114 NSETP 1/min p2000
Power smoothed (3) r0032 PACTV kW r2004
Actual speed value smoothed
Absolute actual current, smoothed
1)
Converter output voltage smoothed
Control factor smoothed r0028 AUSST % Reference modulation
Field-producing current component
Torque-producing current component
Converter overload
Degree of thermal overload
r0036 LTI2T % 100 % = Shutdown
Speed actual value motor encoder
Speed setpoint after the filter
Control deviation r0064 NDIFF 1/min p2000
Output frequency r0066 F_OUT Hz Reference frequency
Control factor r0074 AUSST % Reference modulation
Torque-generating actual current
For further diagnostic purposes
Fixed speed setpoint effective
Active motorized potentiometer setpoint
I component of speed controller
1)
If a temperature sensor has not been installed, a value of –200 °C is displayed.
To Next Page
Loading...
