Mechanical installation
3.3 Mounting
Converter cabinet units
Operating Instructions, 07/2016, A5E03347396A
57
Note
Installing the canopies with cabinets connected in series
There are overlaps on the sides of the canopies to prevent water dripping into the spaces
between c
abinets connected in series. When fitting the canopies, make sure these overlaps
Fitting a hood to increase the degree of protection to IP23/IP43/IP54 (option M23/M43/M54)
Figure 3-16 Attaching a hood
1. Remove the crane transport assembly (if fitted).
2. Make sure that a perforated top cover is not fitted on the top of the cabinet (depending on
production requirements, this can be fitted at a later stage). If a top cover is installed, it
must be removed.
To Next Page
Loading...
