Siemens SINUMERIK 840DE SL - 5.2 Setting data; 5.2.1 Axis;spindlespecific setting data

Data Lists
5.2 Setting data
Axis Monitoring, Protection Zones (A3)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
5-3
Number Identifier: $MA_ Description
36300 ENC_FREQ_LIMIT Encoder limit frequency
36302 ENC_FREQ_LIMIT_LOW Encoder limit frequency resynchronization
36310 ENC_ZERO_MONITORING Zero mark monitoring
36400 CONTOUR_TOL Tolerance band contour monitoring
36500 ENC_CHANGE_TOL Maximum tolerance for position actual value switchover
36600 BRAKE_MODE_CHOICE Deceleration behavior on hardware limit switch
36620 SERVO_DISABLE_DELAY_TIME Cutout delay servo enable
Protection zones
Number Identifier: $MA_ Description
30800 WORK_AREA_CHECK_TYPE Type of checking of working area limits
5.2 5.2 Setting data
5.2.1 Axis/spindlespecific setting data
Axis monitoring functions
Number Identifier: $SA_ Description
43400 WORKAREA_PLUS_ENABLE Working area limitation active in positive direction
43410 WORKAREA_MINUS_ENABLE Working area limitation active in negative direction
43420 WORKAREA_LIMIT_PLUS Working area limitation plus
43430 WORKAREA_LIMIT_MINUS Working area limitation minus
Protection zones
None