Siemens SINUMERIK 840DE SL

To Next Page

To Previous Page

Contents

Spindles (S1)

iv Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0

5 Data Lists................................................................................................................................................ 5-1

5.1 Machine data.............................................................................................................................. 5-1

5.1.1 NC-specific machine data .......................................................................................................... 5-1

5.1.2 Channelspecific machine data ................................................................................................... 5-1

5.1.3 Axis/spindle-specific machine data ............................................................................................ 5-2

5.2 Setting data ................................................................................................................................ 5-3

5.2.1 Channel-specific setting data..................................................................................................... 5-3

5.2.2 Axis/spindle-specific setting data ............................................................................................... 5-4

5.3 Signals........................................................................................................................................ 5-4

5.3.1 Signals to axis/spindle................................................................................................................ 5-4

5.3.2 Signals from axis/spindle ........................................................................................................... 5-5

Index................................................................................................................................................ Index-1

Tables

Table 2-1 Change over to axis mode: ...................................................................................................... 2-24

Table 2-2 Switch back to spindle mode.................................................................................................... 2-24