Siemens SINUMERIK 840DE SL - Page 631

Detailed Description
2.7 Program operation mode
Mode Group, Channel, Program Operation, Reset Response (K1)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
2-95
running
, ... DBX35.0)
stopped
, ... DBX35.2)
Part
program
Start
Part
program
End
_N_PROG_
EVENT_SPF
active
aborted
, ... DBX35.4)
_N_PROG_
EVENT_SPF
End
_N_PROG_
EVENT_SPF
End
Program
status DB21-30
active
, ... DBX35.5)
interrupted
, ... DBX35.6)
Reset
, ... DBX35.7)
Channel status
DB21-30
Fig. 2-9 Time sequence of the interface signals for program status and channel status (1)
For operator panel reset (SW 6.3 and higher):
Time sequence of VDI signals DB21-DB30, ... DBB35 ("Program status" and "Channel
status") when processing with an event-driven program call:
running
, ... DBX35.0)
stopped
, ... DBX35.2)
_N_PROG_
EVENT_SPF
active
aborted
, ... DBX35.4)
_N_PROG_
EVENT_SPF
End
Operator panel
front reset
Program
status DB21-30
active
, ... DBX35.5)
interrupted
, ... DBX35.6)
Reset
, ... DBX35.7)
Channel status
DB21-30
Fig. 2-10 Time sequence of the interface signals for program status and channel status (2)
The chronological sequences from SW 6.3 and higher are shown: