Operation Type
1)
Meaning W
2)
TP
3)
SA
4)
Description see
5)
1)2)3)4)5)
for explanations, see legend (Page 1197).
DIAMONA K Axis-specific modal diameter programming:
ON
Activation, see machine manufacturer
m + PM-NC
DIC K Relative non-modal axis-specific diameter
programming
s + PM-NC
DILF A Retraction path (length) m + PM-NC
DISABLE P Interrupt OFF + - PM-NC
DISC A Transition circle overshoot tool radius com‐
pensation
m + PM-NC
DISCL A Clearance between the end point of the fast
infeed motion and the machining plane
+ PM-NC
DISPLOF PA Suppress current block display + PM-NC
DISPLON PA Revoke suppression of the current block dis‐
play
+ PM-NC
DISPR A Path differential for repositioning s + PM-NC
DISR A Distance for repositioning s + PM-NC
DISRP A Distance between the retraction plane and the
machining plane during smooth approach and
retraction
+ PM-NC
DITE A Thread run-out path m + PM-NC
DITS A Thread run-in path m + PM-NC
DIV K Integer division + PM-NC
DL A Select location-dependent additive tool offset
(DL, total set-up offset)
m + PM-NC
DO K Synchronous action: Triggering of actions
when condition fulfilled
- + FM-SA
DRFOF P Deactivation of handwheel offsets (DRF) m + - PM-NC
DRIVE G Velocity-dependent path acceleration m + PM-NC
DRIVEA P Activate knee-shaped acceleration character‐
istic for the programmed axes
+ - PM-NC
DYNFINISH G Dynamic response for finishing m + PM-NC
DYNNORM
6)
G Standard dynamic response m + PM-NC
DYNPOS G Dynamic response for positioning mode, tap‐
ping
m + PM-NC
DYNPREC G Dynamic response for smooth finishing m + PM-NC
DYNROUGH G Dynamic response for roughing m + PM-NC
DYNSEMIFIN G Dynamic response for semi-finishing m + PM-NC
DZERO P Marks all D numbers of the TO unit as invalid + - PM-NC
EAUTO G Definition of the last spline section by means
of the last 3 points
m + PM-NC
EGDEF P Definition of an electronic gear + - PM-NC
EGDEL P Delete coupling definition for the following axis + - PM-NC
EGOFC P Turn off electronic gear continuously + - PM-NC
EGOFS P Turn off electronic gear selectively + - PM-NC
Tables
4.1 Operations
NC programming
1210 Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
To Next Page
Loading...
Need help?
General
