Operation Type
1)
Meaning W
2)
TP
3)
SA
4)
Description see
5)
1) 2) 3) 4) 5)
for explanations, see legend (Page 1197).
POLFMLIN P Enable axes for retraction with a linear con‐
nection between the axes
m + - PM-NC
POLY G Polynomial interpolation m + PM-NC
POLYPATH P Polynomial interpolation can be selected for
the AXIS or VECT axis groups
m + - PM-NC
PON G Punching ON m + PM-NC
PONS G Punching ON in interpolation cycle m + PM-NC
POS K Axis positioning + + PM-NC
POSA K Position axis across block boundary + + PM-NC
POSM P Position magazine + - FM-TM
POSMT P Position multitool on toolholder at location
number
+ - FM-TM
POSP K Positioning axis in parts (oscillation) + PM-NC
POSRANGE F Determine whether the currently interpolated
position setpoint of an axis is located in a win‐
dow at a predefined reference position
+ + FM-SA
POT F Square
(arithmetic function)
+ + PM-NC
PR K Per revolution + PM-NC
PREPRO PA Identify subprograms with preparation + PM-NC
PRESETON P Actual value setting with loss of the referenc‐
ing status
+ + PM-NC
PRESETONS P Actual value setting with loss of the referenc‐
ing status
+ + PM-NC
PRIO K Keyword for setting the priority for interrupt
processing
+ PM-NC
PRLOC K Initialization of variables at reset only after lo‐
cal change
+ PM-NC
PROC K First operation in a program + PM-NC
PROTA P Request for a recalculation of the collision
model
+ PM-NC
PROTD F Calculating the distance between two protec‐
tion areas
+ PM-NC
PROTS P Setting the protection area status + PM-NC
PSI K Opening angle of the taper + PM-NC
PTP G Point-to-point motion (PTP travel) m + PM-NC
PTPG0 G Point-to-point motion only with G0, otherwise
path motion CP
m + PM-NC
PTPWOC G Point-to-point motion without compensation
movements caused by changes in orientation
m + PM-NC
PUNCHACC P Travel-dependent acceleration for nibbling + - PM-NC
PUTFTOC P Tool fine offset for parallel dressing + - PM-NC
PUTFTOCF P Tool fine offset dependent on a function for
parallel dressing defined with FCTDEF
+ - PM-NC
Tables
4.1 Operations
NC programming
1224 Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
To Next Page
Loading...
Need help?
General
