Siemens SINUMERIK

Programming and Operating Manual (Turning)
01/2017
217
Required tool
Tool type
Tool number
Roughing
Finishing
DIN
ISO
Speed
Feedrate
Speed
Feedrate
35 ° finishing tool
T2D1
T0202
S1000
F0.2
S2000
F0.1
Note
•
When programming in ISO mode, you need to set the H number of T2 to 2 in the tool list;
• Cut the workpiece manually after machining is over.
Operating sequence for programming in Siemens mode
1.
Select the program management operating area.
2.
Press this softkey to enter the system directory for storing part programs.
3.
Press this softkey and enter the name of the new program.
4.
Press this softkey to confirm your entry. The part program editor window opens automatica
l-
ly.
5.
Enter the following program in the window. The control system saves your editing automat
i-
cally.