Siemens SINUMERIK User Manual

Programming and Operating Manual (Turning)
224 01/2017
13.
Move the cursor to "C" in the line for
CYCLE95 with the cursor keys and press this softkey
to insert a marker.
14.
Use the cursor keys to select the entire program block for CYCLE95. Press this softkey to
copy the selection to the buffer memory.
15.
Place the cursor on the end
-of-
block character after "M3 S2000" with cursor keys and press
this key on the MCP to enter a new line.
16.
Paste the content of the buffer memory into the new
line.
17.
Press this softkey to open the window for CYCLE95 again. Move the cursor to the input field
of "VARI".
18.
Press this key to change the value to "5".
19.
Press this softkey to accept the change and continue to enter the following program blocks:
G0 X100 Z100
M05
M30
Then you can proceed with the operations for "
program simulation and execution
(Page
242)".
Screenshots of the complete program
Screen 1:
Screen 2:

Siemens SINUMERIK Specifications

General

Interface	Ethernet, PROFIBUS, PROFINET, USB
Programming Languages	DIN/ISO
Display	TFT color display
Compatibility	Siemens drives and motors
Software	SINUMERIK Operate
Control Unit Type	CNC (Computer Numerical Control)
Safety Functions	Integrated safety functions up to SIL 3/PLe