Siemens SINUMERIK User Manual

Programming and Operating Manual (Turning)
01/2017
229
Operating sequence for programming in Siemens mode
1.
Select the program management operating area.
2.
Press this softkey to enter the system directory for storing part programs.
3.
Press this softkey and enter the name of the
new program.
4.
Press this softkey to confirm yo
ur entry. The part program editor window opens automatical-
ly.
5.
Enter the following program in the window. The control system saves your editing automat
i-
cally.
6.
Open the vertical softkey bar for available turning cycles.
7.
Press this softkey to open the window for CYCLE95 and enter the name of the contour
subroutine in "NPP", for example, "WW".

Siemens SINUMERIK Specifications

General

Brand	Siemens
Model	SINUMERIK
Category	Control Unit
Language	English