Siemens SINUMERIK User Manual

Programming and Operating Manual (Turning)
232 01/2017
25.
Open the w
indow for CYCLE99. Enter the desired parameters as follows:
Note:
Set the parameters visible only with the scroll bar to their default values.
26.
Continue to enter the following program blocks:
G0 X100 Z100
M05
M30
Then you can proceed with the operations for "
program simulation and execution
(Page 242)".
Screenshots of the complete program
Screen 1:
Screen 2:

Siemens SINUMERIK Specifications

General

Interface	Ethernet, PROFIBUS, PROFINET, USB
Programming Languages	DIN/ISO
Display	TFT color display
Compatibility	Siemens drives and motors
Software	SINUMERIK Operate
Control Unit Type	CNC (Computer Numerical Control)
Safety Functions	Integrated safety functions up to SIL 3/PLe