Siemens SINUMERIK

Programming and Operating Manual (Turning)
01/2017
231
18.
Press this key to change the value to "5".
19.
Press this softkey to accept the change and continue to enter the following program blocks:
G0 X100 Z100
M00
T3 D1
M3 S600
G0 X100 Z100
Z
-20
X22
G1 X17 F0.1
X20 F0.5
G0 X50
20.
Open the vertical softkey bar for available turning cycles.
21.
Press this softkey to open the window for CYCLE93. Enter the desired parameters as fo
l-
lows:
22.
Press this softkey to confirm your input.
23.
Enter the following program blocks:
G0 X100 Z100
M00
T4 D1
M3 S600
G0 X100 Z100
24.
Open the vertical softk
ey bar for thread cutting cycles.