Siemens SIREMOBIL Iso-C 3D - Preparations on the Monitor Trolley

6 - 1
Siemens AG SPR2-230.814.01 Page 1 of 42 SIREMOBIL Iso-C 3D
Medical Solutions Rev. 05 08.04 CS PS 24
3. Part of activities independent of serial number6
Preparations on the monitor trolley 6
• Remove the rear panel.
• Remove the cover for the system manual drawer (Fig. 1).
• Remove the cable ties.
• Remove the front cover (Fig. 2).
Remove the cable ties and/or shielding connections as required
during the installation.
After successful installation, reattach the shielding und secure
the cables with the cable ties.
Remove the Dicom bridge, if there is one.
Fig. 1 System manual drawer Fig. 2 Front cover of system manual drawer
NOTE