Siemens SIREMOBIL Iso-C 3D - Cut-Off Delay D210, Item No. 71 40 071

3. Part of activities independent of serial number 6 - 25
Siemens AG SPR2-230.814.01 Page 25 of 42 SIREMOBIL Iso-C 3D
Medical Solutions Rev. 05 08.04 CS PS 24
Cut-off delay D210, item no. 71 40 071 6
• Remove the 4 nuts and the toothed washers at the mains input filter.
• Attach the 4 spacers (= hexagonal bolts) M5 (see Fig. 63).
• Position the support tray and attach it with screws (see Fig. 65).
• Attach the D210 cut-off delay(Fig. 64) on the support (Fig. 66).
• Secure it with toothed washers and nuts.
Fig. 64 Mains input filter with mounted spacer bolts Fig. 65 Cut-off delay D210
Fig. 66 Support tray installed Fig. 67 Side view of installed D210
Markierung für Tastaturschublade
Markierung für Tastaturschublade