Siemens SIREMOBIL Iso-C 3D - Covers; Attaching the PC Covers

3. Part of activities independent of serial number 6 - 41
Siemens AG SPR2-230.814.01 Page 41 of 42 SIREMOBIL Iso-C 3D
Medical Solutions Rev. 05 08.04 CS PS 24
Covers 6
Attaching the PC covers 6
• Connect the protective conductor (1000 mm long) from the front cover of the base plate
to the PC support (Fig. 95).
• Attach the front cover (Fig. 94).
• Connect the protective conductor (150 mm long) from the side cover of the base plate to
the PC support.
• Connect the protective conductor (550 mm long) from the rear panel of the PC to the
base plate of the PC support.
• Route the protective conductor from the base plate of the PC support to the protective
conductor bar in the monitor trolley and connect it.
• Attach the rear panel of the monitor trolley.
• Affix the 3D label to the monitor (Fig. 96).
Fig. 95 PC with covers Fig. 96 Grounding of PC housing
Fig. 97 3D label
3D label