Siemens SIRIUS 3RT - Snapping Onto DIN Rail (Snap-On Mounting)

Mounting
7.2 Mounting
SIRIUS - SIRIUS 3RT Contactors/Contactor assemblies
Manual, 09/2017, A5E03656507120A/RS-AE/006
185
7.2.4
Snapping onto DIN rail (snap-on mounting)
Mounting / disassembling sizes S00 to S3 (snap-on mounting)
Contactors of sizes S00 to S3 can be snapped onto a 35 mm standard mounting rail.
Mounting / disassembling size S00 (snap-on mounting)
①
Position the device on the top edge of the mounting rail and press it down until it snaps onto
the bottom edge of the rail.
To disassemble the device, press it down, pushing against the mounting springs, and swivel
the device to remove it.
Mounting / disassembling size S0 (snap-on mounting)
①
Position the device on the top edge of the mounting rail and press it down until it snaps onto
the bottom edge of the rail.
To disassemble the device, press it down, pushing against the mounting springs, and swivel
the device to remove it.