Siemens SITRANS F - Datalogger Setup Menu Structure; Datalogger Mode; Datalogger Data

2-57
1010ENFM-3B
Section 2
2.9.1 DATALOGGER MODE
The [Datalogger Mode] option list allows you to disable Datalogger, transmit reports to an external target
via RS-232 port, or store selected data for later display. The default setting is [Off]. After enabling the
Datalogger, select a data format before generating a report.
To select a Datalogger Mode:
To access the [Datalogger Mode] option list press
T move the cursor to the desired mode press
To store the selection press
2.9.2 DATALOGGER DATA
Set the Datalogger to record any or all of the data offered on the Datalogger Data option list shown on
next page. However, recording unneeded data wastes valuable system RAM. We recommend that you
always select [Site ID] (name) and [Time] to identify each line of data.
ENT
Datalogger Mode Off
Datalogger Data None
Log Time Interval 1 Min.
Data Logger Events None
Display Datalogger Off
Siemens Dual Path Path 1
Select datalogger destination
Datalogger Setup
Use this menu cell
to select a logging
interval.
Use this menu cell to
send Datalogger reports
to selected a destination
and pick a line wrap
mode.
Use this menu cell to
pick a destination for
Datalogger reports.
Use this menu cell to
select real-time
Datalogger triggers.
Use this menu cell to
select items fo
r
Datalogger reports.
Datalogger Setup Datalogger Events Relay 1
Relay 2
Spacing
Empty
Aeration
Interface
Flow Alarm
Fault Alarm
Memory
Makeup
Td Alarm
Ts Alarm
Display Datalogger Off
No Line Wrap
Line Wrap
Ö
Ö
Ú
Ú
Ú
Ú
Ú
Ö
Ö
DATALOGGER SETUP MENU STRUCTURE (continued)