Siemens SITRANS F - Creating a New Site Setup

1-11
1010ENFM-3BSection 1
Press <Right Arrow>. Note that the cursor changes to a block, which appears after a question mark
(?). This indicates that you have accessed the first character position of an eight-character (maxi-
mum) alphanumeric entry field.
Channel 1 >Clamp-on
Channel 2 FlowTube
Reflexor
Siemens 2 Channel [1] Channel 1
Choose Channel 1 Flowmeter Type
Dual Channel Energy
Siemens 2 Channel [1] Channel 1
Recall Site Setup No Sites
Channel Enable No
Create/Name Site
Site Security Off
Delete Site Setup No Sites
Save/Rename Site
Right Arrow & Enter Creates a new Site
Channel Setup
To select [Clamp-On] press the <Right Arrow>. This selects the Clamp-On installation menu for
Measurement Channel 1. Note that the first menu, [Channel Setup] is highlighted.
Creating a New Site Setup
Always begin a new installation by issuing the [Create/Name Site] command. Although you do not
need to enter a site name to create a new site setup, you have to provide one to save the site setup or
identify the data source. In this example, we will name this [SITE1].
To access the [Channel Setup] menu, press the <Right Arrow>,then move the highlight down to
[Create/Name Site].
Siemens 2 Channel [1] Channel 1
Recall Site Setup No Sites
Channel Enable No
Create/Name Site ?



Site Security Off
Delete Site Setup No Sites
Save/Rename Site
Right Arrow & Enter Creates a new Site
Channel Setup
This block cursor is
currently placed at
the first character
position.