1-12
1010ENFM-3B
Section 1
Press and hold the <UP Arrow>. Note that the character position begins to scroll up through the
alphabet of capital letters. Continue to scroll until the block cursor shows [S].
Press the <Right Arrow>. [S] remains at first position and the cursor moves to the second character
position.
Press and hold the <Right Arrow>. Note that the capitalized alphabet list begins to scroll downward
through the alphabet from [S]. Stop scrolling at letter [I].
Press the <Right Arrow> to move the cursor to third position. Scroll back up to letter [T]. Move cursor
to fourth position. Scroll down to letter [E]. Move the cursor to fifth position. Type [1] on keypad to
complete site name.
Press <ENT> to create a site setup named [SITE1]. Note that the name now appears in the [Save/
Rename Site] menu cell and on the upper right corner of the graphic screen.
Siemens 2 Channel [1] Channel 1
Recall Site Setup No Sites
Channel Enable No
Create/Name Site ?S
Site Security Off
Delete Site Setup No Sites
Save/Rename Site
Right Arrow & Enter Creates a new Site
Channel Setup
Siemens 2 Channel [1] Channel 1
Recall Site Setup No Sites
Channel Enable No
Create/Name Site ?SITE1
Site Security Off
Delete Site Setup No Sites
Save/Rename Site
Right Arrow & Enter Creates a new Site
Channel Setup
Siemens 2 Channel [1] SITE1
Recall Site Setup No Sites
Channel Enable No
Create/Name Site SITE1
Site Security Off
Delete Site Setup No Sites
Save/Rename Site SITE1
Use with Care -- Turn Security On or Off
Channel Setup
After creating a Site
Setup, the assigned
name appears in
these places.
To Next Page
Loading...
