Siemens SITRANS F - 2.7 The Data Span;Set;Cal Menu

2-45
1010ENFM-3B
Section 2
Siemens 2 Channel [1] Channel 1
Define data Alarm thresholds
Data Span/Set/Cal
Span Data
Set Alarm Levels
Calibrate Flowrate Intrinsic
Use this menu to define
setpoints for the alarm
relay outputs.
Use this menu to set the
low and high range for
analog outputs.
Use this menu cell to
enter a calibration
slope factor for
volumetric flow (Vfo).
Data Span/Set/Cal Span Data Max Energy Flow x.xxx (numeric entry)
Min Energy Flow x.xxx (numeric entry)
Max Flow (Units) x.xxx (numeric entry)
Min Flow (Units) x.xxx (numeric entry)
Max Ts xx.x (numeric entry)
Min Ts xx.x (numeric entry)
Max Tr xx.x (numeric entry)
Min Tr xx.x (numeric entry)
Max Td xx.x (numeric entry)
Max CE (Units)* xx.x (numeric entry)
Min CE (Units)* xx.x (numeric entry)
Max Vs m/s x.xxx (numeric entry)
Min Vs m/s x.xxx (numeric entry)
Set Alarm Levels High Energy Rate x.xxx (numeric entry)
Low Energy Rate x.xxx (numeric entry)
High CE (Units)* x.xxx (numeric entry)
Low CE (Units)* x.xxx (numeric entry)
High Flow x.xxx (numeric entry)
Low Flow x.xxx (numeric entry)
High Td xx.x (numeric entry)
Low Td xx.x (numeric entry)
High Ts xx.x (numeric entry)
Low Ts xx.x (numeric entry)
Interface Vs m/s x.xxx (numeric entry)
Aeration % x.xxx (numeric entry)
Makeup Latch Off
On
Calibrate Flowrate Intrinsic
Kc numeric entry
Multipoint Point # xx (numeric entry)
Indicated Rate x.xxx (numeric entry)
% Correction x.xxx (numeric entry)
THE DATA SPAN/SET/CAL MENU STRUCTURE
Ú
Ú
Ú
Ú
Ú
Ö
Ö
Ö
Ö
Ö
Ú
Ú
Ú
Ú
Ö
*Only available on units equipped with Analog Input capability.