1-3
1010ENFM-3BSection 1
1.5 THE FUE1010EN KEYPAD
The FUE1010EN integral keypad provides 32 numeric and function keys (see table below). Use these
keys to enter, review or edit the site data. Certain keys control the graphics display, Datalogger and
Totalizer. “Blind Models,” having no keypad or display, must be setup by using their serial data port
(Appendix B).
NOTE: The keypad does not have alphabetic keys. Scrolling lists provide alphanumeric charac-
ters as needed.
1.6 INTRODUCTION TO THE FUE1010EN MENU SCREENS
The figure below shows a typical FUE1010EN menu screen (in this case, the Pipe Data Menu).
TYPICAL INSTALLATION MENU SCREEN
Highlighted Data
Siemens 2 Channel [1] ABC
Select Pipe Class from Pipe Table
Select Pipe Size No Pipes
Pipe OD <in> 0.500
Pipe Material Steel
Wall Thickness 0.100
Liner Material None
Liner Thickness 0.000
Select Pipe Class Manual Entry
Pipe Data
Menu Cell Data
(right-hand column)
Current Selected
Measurement
Channel
Current Selected
Meter Type
Highlighted
Menu Cell
Menu Cell Data
(left-hand column)
Menu Prompt Line
(Reverse Video)
Site Name Identified
Current Selected Menu
KEYPAD FUNCTION CHART
MENU Press to activate the Installation Menu.
ENT Press <ENT> to store numeric data, select from option lists, etc.
LEFT, RIGHT ARROWS Menu navigation keys move cursor in respective directions.
UP, DOWN ARROWS Same as <Left> and <Right>. Also scrolls option list and graphic display
screen.
CLR Clear Key for erasing data, or selecting list options.
NUMBERS 0-9 Use to type numeric data.
DECIMAL POINT Use for decimal points in numeric data.
MATH OPERATORS Allows 4-function math operations in numeric entry cells.
“F” KEYS 1-3 Totalizer control and special function keys.
“F4” KEY CAUTION: SYSTEM RESET KEY (during power up)
CTL & ALT Used as shift keys for alternate key functions.
DATALOG Triggers immediate Datalogger report.
PLUS/MINUS [+/-] Changes the sign of numeric data.
KEY USAGE
To Next Page
Loading...
