2-10
1010ENFM-3B
Section 2
NOTE: Do not use ASA schedule code to specify the wall thickness. You must enter actual di-
mensions.
To enter the Pipe Wall Thickness:
To enable numeric entry press
Use the keypad’s numeric keys to type wall thickness in inches or millimeters.
To register the pipe wall thickness press
2.2.6 LINER MATERIAL
For lined pipes, select a pipe liner from the material option list. If the pipe liner material does not appear
on the list then select the closest type available. If necessary, call Customer Service for additional help.
The system default Liner Material is [None]. If the pipe does not have a liner, press the <Down Arrow>
twice to bypass to the next two menu cells. The Liner Material option list offers a selection of common
liner materials.
To select a Liner Material:
To access the [Liner Material] option list press
To scroll to the required Liner Material press
To register selection press
2.2.7 LINER THICKNESS
If you specified a pipe liner in the Liner Material menu cell, then use this menu cell to set its exact thick-
ness in appropriate units (English or Metric).
To enter a Liner Thickness:
To enable numeric entry press
Use the number keys to type the exact line thickness value.
To register the data press
2.3 THE APPLICATION DATA MENU
This Menu becomes available after picking a Meter Type, Measurement Channel and Measurement Tech-
nology. Use of this menu is optional.
CAUTION: An erroneous Viscosity entry could affect the flowmeter’s intrinsic calibration.
Do not alter the default viscosity value of your liquid unless you are sure of
your data.
ENT
ENT
ENT
To Next Page
Loading...
