4-16
1010ENFM-3B
Section 4
4.11 THE FUE1010EN GRAPHIC DISPLAY SCREENS
The FUE1010EN Graphic Display Sub-System is a versatile resource which provides visual access to all
system variables and conditions. Depending upon your selection, details of the display my vary, but all
elements are always clearly labeled with units and variable names. You’re always free to move through
the displays by using the arrow keys. The meter will hold the last display selected indefinitely or until the
menu is selected by pressing the <Menu> key. When you again leave the menu, the last selected display
will be shown upon your return.
After completing the Site Setup, check your local display screen to ensure that everything is operating
properly. The meter begins to measure flow as soon as you complete the transducer installation.
When you press the <MENU> key to leave the menu, the hybrid digital display screen will appear (shown
on page 17). Note that it includes a
digital flow, total numeric display and a Stripchart.
The StripChart Contains a number of special elements that deserve mention:
z The spanning of the stripchart’s vertical axis obeys the same user settings that define the
span limits for the analog outputs. If the variable “pegs,” the numerical expression of that
variable will also peg.
z Alarm limits, or thresholds, are indicated by triangular cursors shown near the stripchart
bar. These are also defined in the Data Span/Set/Cal area of the menu.
z Each time the stripchart is altered in a manner that can cause misinterpretation of already
displayed data (re-spanned, new interval, etc.), a vertical bar is drawn on the stripchart.
Only the data to the left of the vertical bar is correctly displayed.
z Due to limitations in display area, certain rate or total units may be displayed with fewer
characters than are needed for unambiguous interpretation. Consult the FUE1010EN Flow
and Total Units menu cells for clarification in these cases.
4.9 BACKLIGHT
This menu cell allows you to specify how long you want the LCD Display backlighting to remain on. Select
[On] for continuous illumination. Press the <Right Arrow> to access the option list and then scroll to
desired time delay (before turn-off). Press <ENT> to store your setting.
4.10 SYSTEM INFO
This menu provides general information about the flowmeter.
Version This is the meter’s operating system version number. The Technical Services
Group may request this number during consultations.
Reset Date/Time Shows the date and time of this meter’s last <F4> reset.
Op System P/N Meter’s operating system part number.
Checksum Operating System verifying code. The Technical Services Group may request this
number during consultations.
Code Software Compile Date/Time. Operating System identifier. The Technical Services
Group may request this number during consultations.
System Time Use to set system time and date. Format: xx.xx.xx xx.xx.xx
System Info Menu Structure
To Next Page
Loading...
