Silca Idea - Page 105

Copyright Silca 2004 101
Operating Manual - English IDEA
D IMENSION CHECK WITH C OPY FROM O RIGINAL
(after making the Cutting Test)
After carrying out the Cutting Test, proceed as follows:
Choose 0 “Copy from Original” from the main menu and press ENTER
Choose 3 “Pompa” and press ENTER.
Choose 1 “Reading + Cutting” and press ENTER.
Follow the instructions on the display .
Press START.
Follow the instructions on the display .
Fit the key blank into the clamp (see ch. 5.9 on page 32), then press START.
0 - Copy from Original
1 - Decode and Copy
2 - Insert cuts
3 - Queue from PC
SELECT TYPE OF KEY
0 - Bit stop male
1 - Bit stop female
2 - Shoulder stop
3 - Pump
4 - Square-square tip
5 - Square-round tip
6 - Square stepped tip
1 - Reading + Cutting
2 - Cutting only
3 - Reading only
4 - Post-Reading adj.
KEY READING
Original on right
Clamp.: S100 A Stop: 3
Adap.E7 (START)
Reading in progress….
Date processing
in progress
in corso…
Left blank Brass
Clamp: S1-K1 Stop: 0
Cutt: 1.25 Adap. E3
Pcs = 1/1 (START)
Cutting in progress
Copy: 1 of: 1