Copyright Silca 2004 103
Operating Manual - English IDEA
Example:
[ENTER] = in the last field to quit the window so that the query Save? appears for the edited data.
[START] = press START to begin the automatic gauging procedure or the CLAMP-TAILSTOCK unit.
Digit the corrections required for axis X and axis Y. Press ENTER.
ATTENTION: if [STOP] is pressed the new measurements are not saved; the previous gauging values therefore
remain valid.
Press ENTER to confirm the data.
Adapter E7
Side: Reading
Adjustments: B=+000
X=+10 Y1=+10 Y2=+00
Save
adjustment ?
No=STOP Yes=ENTER
To Next Page
Loading...
