104 Copyright Silca 2004
IDEA Operating Manual - English
D
IMENSIONAL
C
HECK
- CUTTING TEST
FOR
REAR STOP
To check the machine’s precision, proceed as follows:
Choose “2 Insert cuts” from the main menu and press ENTER
.
Choose SSN = 110 and press ENTER.
Enter the depth for bit 1 as in the example
:
Press ENTER
Fit the key blank into the S1 - K2 clamp (see ch. 5.12 on page 43), then press START.
Press STOP, remove the key and use a centesimal gauge to mesure it.
Fig. 128
Measurement X should be 17,30 mm (….inch), +/- 0,03 mm
Measurement Y (Y1+Y2) should be 11,25 mm (…inch) +/- 0,03 mm
0 - Copy from Original
1 - Decode and Copy
2 - Insert cuts
3 - Queue from PC >>
SSN = 110 (Cut)
Marca =
= FICHET
Sans-Soucis P.P.
Bit 1 (Simm. F-R)
#.......###.......#
Possible depths
0123456789# (2)
Bit 1 (Simm. F-R)
#11###11###11###11#
Possible depths
123456# (8)
SSN: 110 M1 Brass
Clamp: S1 – K1 Stop: 1
Cutt.: 1.25
Pcs. 1 / 1 (START)
Cutting in progress
Copy: 1 of: 1
Bit 1
Cutting in progress
Copy: 1 of: 1
Bit 2
Copy 1 of 1
finished
More copies?
No=STOP Yes=ENTER
To Next Page
Loading...
