4100ES-S1 Programming Guide Document: LT0400
Appendices
12-12
12.3.3 Example Alarm and Fault Test equations
These equations (with point number modifications) must be included for each zone to carry
out the zone alarm or fault test when the zone button is pressed and alarm or fault test
modes are active.
5-1 ZONE 1 Alarm Test
[INPUTS]
STATUS ON
P514 | DIGITAL | UTILITY | ALARM TEST
AND STATUS ON
P901 | DIGITAL | UTILITY | MULTIFUNCTION SWITCH - ZONE 1
[END INPUTS]
[OUTPUTS]
HOLD ON PRI=9,9
P1001 | DIGITAL | FIRE | ALARM TEST ZONE 1
[END OUTPUTS]
5-2 ZONE 1 Fault Test
[INPUTS]
STATUS ON
P515 | DIGITAL | UTILITY | FAULT TEST
AND STATUS ON
P901 | DIGITAL | UTILITY | MULTIFUNCTION SWITCH - ZONE 1
[END INPUTS]
[OUTPUTS]
HOLD ON PRI=9,9
P1101 | DIGITAL | TROUBLE | FAULT TEST ZONE 1
[END OUTPUTS]
12.3.4 A/C Reset Button and A/C Trip LED
The A/C Trip LED indicates that the Air Condition system Automatic control has activated.
The A/C Reset button is used to disable the automatic control.
References
Push Button Mode set to “PBT” Mode
Point Address: 0-5-2 A/C Reset Button
P522 A/C Reset Status
0-5-7 A/C Trip LED
P521 Status of A/C Trip
Equations:
3-17 A/C Trip Reset
[INPUTS]
STATUS ON
P522 | DIGITAL | UTILITY | A/C RESET
AND NOT STATUS ON
L257 | LIST | DPSEUDO | GENERAL FIRE TRIP LIST (ACF ISOLATABLE)
OR STATUS ON
P517 | DIGITAL | SUPERV | ACF ISOLATE
[END INPUTS]
[OUTPUTS]
HOLD OFF PRI=9,9
P521 | DIGITAL | UTILITY | A/C TRIP
[END OUTPUTS]
To Next Page
Loading...
Need help?
General
