Document: LT0400 4100ES-S1 Programming Guide
Adding Addressable Devices
Select the required devices by
highlighting the device and pressing the
SPACE bar.
Two red chevrons “>>” indicate the
device has been tagged.
Press OK when all devices are tagged
for this zone.
Note: If a point is inadvertently un-tagged, it might be necessary to use the Filter function to
find the appropriate point to re-tag it back into the Zone List, e.g., if L261 ALARM LIST
ZONE 1 has lost its ALARM TEST ZONE 1 digital point, the filter function can be used to find
and retag the User Digital Pseudo P1001.
To Next Page
Loading...
